Pipe Connections Between Indoor And Outdoor Unit; Preparation Work - LG MULTI VS AARUN040LSS5 Installation Manual

PIPE CONNECTIONS BETWEEN INDOOR AND OUTDOOR UNIT

28
PIPE CONNECTIONS BETWEEN INDOOR AND
OUTDOOR UNIT
- Pipe connections can be done on the front side or on the side according to the installation.
- Be sure to let 0.2 kgf/cm
- If Nitrogen was not flown during welding, many oxidized membranes may form inside the pipe
and disturb the normal operations of valves and condensers.
Front Pipe
Draw Out
Bottom Side Pipe
Draw Out

Preparation Work

- Use Knock Outs of Base Pan of the outdoor unit for Left/Right or Bottom pipe drawing outs.
Removal Area for Liquid/Gas pipe
bottom side connections.
CAUTION
!
• Do not give damage to the pipe/base during the Knock Out work.
• Proceed to pipe work after removing burr after Knock Out work.
• Perform sleeve work to prevent damage to the wire when connecting wires using knock Outs.
• Take care so that there is no thermal damage on the service valves of the outdoor unit.
(Especially packing part of service port.) Wrap the service valve with a wet towel when
brazing it as shown figure above.
2
Nitrogen flow in the pipe when welding.
Rear Side Pipe
Draw Out
NOTE
Right Side Pipe
Draw Out
Pipes and wires should be purchased separately
for installation of the product.
Refrigerant Pipe
Nitrogen Nitrogen Nitrogen
Direction Direction Direction
Taping
<Liquid pipe>
※Pictures may differ depending on the model.
Regulator
Valve
Nitrogen
Wet towel
<Gas pipe>