Advertisement
Available languages
Available languages
persons in order to avoid hazard.
The unit is not waterproof, if there is some humidity, water or fog liquid in it, please switch off the power and
contact the distributor as soon as possible.
There are no spare parts inside machine. If the unit needs to be repaired, please contact your dealer of an
experienced technician.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire
shall be destroyed.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Avoid fire:
Keep out of the reach of children. Don't leave the unit unattended when children are present.
Don't spray the fog directly to people and into an open flame.
The nozzle becomes very hot during operation. So please leave at least 1m distance between the unit and
other materials.
Put the machine at a well-ventilated place and don't cover the ventilation holes. Leave at least 1m of space
around the fog machine. Keep a distance of at least 3m between the fog machine and inflammable materials.
Avoid explosion
Don't add tinder liquid such as oil, gas, perfume and etc. in fog machine.
Please use high quality fog liquid recommended by your dealer. Bad quality fog liquid may damage the unit.
Check regularly if there is enough fog liquid left in the tank.
Remove all fog liquid from the unit before transport.
Don't swallow fog liquid. In case of accidental ingestion, contact immediately a doctor. Rinse thoroughly your
skin and eyes if they have been in contact with the fog liquid.
Repair:
Please clean the fog machine regularly to avoid problems.
Close the cap of the fluid tank thoroughly after filling in fog liquid.
After about 40 hours continually use, please use 80% distilled water and 20% vinegar to remove the dirt in the
nozzle. Let the unit cool down. Disassemble the nozzle and use vinegar and a pipe cleaner to clean it. Make
sure that the unit is unobstructed.
Empty the tank and fill in cleaning fluid. Plug the unit into a wall outlet and heat it up as usually.
Run it in a well-ventilated place until the tank is empty.
Replace the nozzle. Unplug the unit and fill it with normal fog fluid..
Clean timely to extend the lifespan of machine.
Use dry cloths to clean machine and keep dry while store.
Technical parameter:
Voltage: ................................................................................................. AC 220-240V 50Hz
Power: ........................................................................................................................ 400W
Heat-up time: .............................................................................................................. 5 min
Tank Capacity: .............................................................................................................. 0.3L
Projection Distance: ..................................................................................................... 3.5m
©Lotronic- 2015
Fog machine
3
Advertisement
