Download Print this page

Boost -FOG400LED-BK Instruction Manual page 2

400w fog machine with 3 leds black / white

Advertisement

Available languages

Available languages

G
B
-
4
G
B
-
4
Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or
damage due to misuse. Thank you for purchasing this high quality, well-performing BOOST fog
machine that will give you entire satisfaction.
The appliance is only to be used with the recommended vaporizing medium. The use of other substances
may give rise to a toxic or fire risk.
This appliance shall not be used by children below the age of 14 nor persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge even if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children.
Please note that the unit is not for intensive professional use. FOR SAFETY REASONS, DO NOT
LEAVE THE UNIT SWITCHED ON OVER AN EXTENDED PERIOD OF TIME.
Installation:
1. Take away all packing material especially in the nozzle.
2. Set the unit on a level surface and loosen the cap of the fluid tank.
3. Add high quality water based fog liquid in the machine and screw the cap of the fluid tank. Bad quality fog
liquid will damage fog machine.
4. Plug the unit into an earthed mains outlet.
Operation:
1. Please turn on the unit via the switch on the rear panel. The machine will start heating up. Set the I/O
switch on the remote to "I" to start the fog machine. When it has reached operating temperature, the neon
switch on the remote control lights up. Occasionally the neon switch will turn off and the pump will stop.
This means that the unit has cooled down and requires re-heating, the pump will not operate whilst the
heater is on and the switch will illuminate when the machine is again ready to use.
2. Often check whether there has enough fog liquid in machine. The operation will make big damage to the
machine if there has no fog liquid.
3. If the fog output is low, the unit makes an unusual noise or there is no fog output at all, please power off
and check fog liquid, fuse and power plug. If the problem hasn't been solved after checking these parts,
send it back to your dealer for repair.
Attention:
Please adhere to all operation, safety and repair instructions to avoid getting an electric shock and keep the
unit in excellent working condition.
Keep the unit clean
For indoor use only
Make sure your mains outlet delivers the voltage required for this fog machine.
Put the unit on a level surface and don't tilt or turn it upside down.
Power off or pull out plug after use.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
©Lotronic- 2015
0
0
W
F
o
g
0
0
W
F
o
g
Fog machine
M
a
c
h
i
n
e
M
a
c
h
i
n
e
w
i
t
h
3
L
E
w
i
t
h
3
L
E
D
s
D
s
2

Advertisement

loading

This manual is also suitable for:

Boost-fog400led-wh