Table of Contents
Advertisement
SPECIFICATIOnS
Electrical
120 V~ / 60 Hz
Requirements
Power Plug: 20 Amp/3 Prong / Grounded
Input Current
20 Amps
Power Switch
Rocker with Light (Yellow)
Type
Indicators
Thermal Overload Light (Red)
Minimum: 50 Amp
Settings
Maximum: 70 Amp
Welding
Up to 1/8" Thick Steel in a Single Pass
Capacity
Recommended
1/16" Diameter for 15 Amp Circuits
Electrode Size
Up to 5/64" Diameter for 20 Amp Circuits
Duty Cycle
10% @ 70 Amps / 20% @ 50 Amps
Welding Shield (Qty. 1)
Hammer/Brush (Qty. 1)
Accessories
Electrode Holder (Qty. 1)
Ground Clamp (Qty. 1)
unPACKIng
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as pos-
sible.
InITIAL SET uP
InSTRuCTIOnS
Read the EnTIRE IMPORTAnT
SAFETY InFORMATIOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
SKU 97717
For technical questions, please call 1-800-444-3353.
WARnIng
InjuRY FROM ACCIDEnTAL
OPERATIOn:
Turn the Power Switch of the
tool to its "OFF" position
and unplug the tool from
its electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
1.
To assemble the Welding Shield,
place the Shield on a flat surface.
Press the Handle into place. Then
insert the Filter Lens.
(See Figure A.)
FIguRE A
2.
This Arc Welder is equipped with a
120 volt, 20 Amp, 3-prong, grounded
Power Plug (8). If this Plug does not
fit your existing 120 volt electrical
outlet, have a qualified electrician
TO PREVEnT
SERIOuS
Page 9
Advertisement
Table of Contents
