Whirlpool WDT970SAHW User Instructions page 9

OPTION SELECTIONS
Runs dishwasher at a later time. Select a wash cycle
and options. Each time you press the Delay keypad, it
will display the next available delay time. Press DELAY.
Press the START/RESUME keypad. Close door firmly.
NOTES:
The dishwasher remembers the last Delay you
(varies by
■
selected. To reset the delay time to something
model)
other than what is displayed, continue to press
the Delay keypad until the desired delay time
is reached.
Anytime the door is opened (such as, to add a
■
dish), Start/Resume must be pressed again to
resume delay countdown.
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Dries dishes with heat. This option, with the use of
rinse aid, will provide better drying performance. Plastic
items are less likely to deform when loaded in the top
rack. Use Heat Dry for optimum dry performance. Turn
the Heat Dry option off for air dry.
Extended Dry lengthens the time that Heat Dry is active.
This option with the use of rinse aid will provide better
drying performance.
Sanitizes dishes and glassware in accordance with NSF
International NSF/ANSI Standard 184 for Residential
Dishwashers. Certified residential dishwashers are
not intended for licensed food establishments. Only
sanitizing cycles have been designed to meet the
(location of
requirements of the NSF/ANSI 184 performance
"Sanitized"
standard for soil removal and for sanitization efficacy.
indicator
There is no intention, either directly or indirectly, that
varies by
all cycles on a NSF/ANSI 184 certified dishwasher
model)
meet the NSF/ANSI 184 performance standard for soil
removal and for sanitization efficacy.
At end of the cycle, the "Sanitized" indicator will glow.
If your load did not properly sanitize, the indicator will
flash at the end of the cycle. This can happen if the
cycle is interrupted or if the water does not reach the
required temperature. The light goes off when you open
and close the door or press CANCEL.
Avoids unintended use of dishwasher between cycles or cycle and option changes during a cycle.
To turn on Control Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked,
the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off.
OPTIONS CAN BE WHAT IT DOES ADDED
SELECTED
WITH
Available with Delays start of
any cycle a cycle up to
24 hours.
Sensor Raises the
Heavy main wash
Normal temperature to
Soak & Clean 135°F (57°C).
Sensor
Uses heating
Heavy
element to speed
Normal
drying times.
Soak & Clean
Heat Dry option
defaults to On
when any cycle is
selected, except
for 1-Hour Wash.
Sensor Raises the
Heavy main wash
Normal temperature to
135°F (57°C) and
the final rinse
temperature to
156°F (69°C).
ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)
NA NA
0:05 to 0 to 3.86
0:13 (0 to 14.6)
0:08 to 0
0:46
0:05 to 0 to 3.86
1:06 (0 to 14.6)
9