HOME ELEMENT LU-2520 User Manual page 7

Do not use with damaged cord, plug or other injuries.
•
Keep the power cord away from sharp edges and hot surfaces.
•
Do not pull the cord. Always take the plug. Do not reel the cord around the device housing.
•
Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.
•
Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
•
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged if not in use.
•
To avoid electric shock and fire, do not immerse in water or other liquids. If that occurs, immediately unplug the appliance and contact service center for inspection.
•
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
•
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Never drop or insert any object into any opening on the appliance.
•
Make sure before use that blades are aligned properly.
•
Do not place the appliance on a surface while it is operating.
•
Do not use the appliance with a damaged or broken comb or with teeth missing from the blades as injury may occur.
•
NOTE: keep the blades oiled!
INSTRUCTIONS FOR HAIR CUTTING
Before starting a hair cut inspect the clipper, ensure that it is free of oil between the cutting blade teeth.
•
Switch the appliance on to distribute the oil and make sure it is running smoothly. Wipe off any excess oil.
•
While using the appliance, untwist the cord from time to time to avoid tangling.
•
Seat the person so that the head is at your eyes level. That provides better control of hair cutting.
•
Before cutting comb hair to ensure that there are no tangles.
•
Place a towel around the neck and over shoulders of the person having the haircut.
•
NOTE: When you use the hair clipper for the first time, the appliance may vibrate and make a snapping sound. This is normal and is a feature of the design.
EXTRA COMBS
Attachment comb № 1 leaves 3 mm hair length.
•
Attachment comb № 2 leaves 6 mm hair length.
•
Attachment comb № 3 leaves 9 mm hair length.
•
Attachment comb № 4 leaves 12 mm hair length.
•
To attach a comb hold it with its teeth upward and slide it onto and along the clipper blade until the front of the comb firmly placed against the clipper blade.
•
When you use the clipper for the first time, cut only small portions of hair until you are accustomed to the cutting length with a certain comb attachment.
•
For even cutting, allow the comb attachment/cutter to cut its way through the hair. Do not force it through quickly. Also remember to comb the hair frequently to remove trimmed hair and check for
•
uneven strands.
BLADE ADJUSTMENT LEVEL
The lever of blade adjustment is located near your thumb (if you are right-handed) so it can easily be adjusted while the clipper is in your hand.
•
The blade adjustment level adds versatility to your clipper. It allows you changing gradually the length of your haircut without a comb.
•
When the level is in the upper position, the blades make the shortest cut.
•
• Pushing the lever downward gradually you could increase the length of haircut.
In the lowest position of the lever hair length is approximately the same as after № 1(3mm) comb.
•
The level also extends the use of your blades as different cutting edge is used in each setting.
•
To remove stuck hair move rapidly the lever from lower to upper position several times.
•
7