Table of Contents
Advertisement
TROUBLE SHOOTING GUIDE
If a problem occurs check below to see whether this can be solved.
In the unlikely event that the problem cannot be rectified, please contact a
service engineer.
Problem
No lights come on when the
power is turned on.
The machine does not start.
Water is not pumped away.
(The display show "
The display shows "
(Automatically Drain Pump operated.)
The display shows "
The display shows "
The display shows "
The spray arms do not rotate
smoothly.
White deposits are left on the
dish washer after washing.
Streaks are left on glassware.
Dry results are not satisfactory.
Washing results are not
satisfactory.
The display shows "
Possible Causes
• Plug is not properly inserted into the socket.
• Fuse blown or circuit breaker tripped.
• The electricity of the house was cut off.
• Door is not fully closed.
• The start button is not pressed.
• The drain hose is kinked.
" code.)
• The filter is clogged. (Clean the filter.)
" code.
• Excessive water is supplied than the normal water level.
• There is a problem with the inlet valve.
" code.
• Water is not supplied. (Water tap is not opened.)
" code.
• Water is leaking from the Hose connections.
• Damage to the unit has been caused by a water leak.
" code.
• The water heater circuit is damaged.
• The mounting of the spray arms is blocked by food
particles. (Clean the holes of the spray arm.)
• The amount of detergent or rinse-aid set incorrectly.
• The salt container is empty.
• The salt container cap is not securely screwed on.
• Too little Rinse-Aid dispensed.
• Too little Rinse-Aid dispensed.
• Incorrect amount of detergent.
• Utensils incorrectly arranged or overloaded.
• Filters are clogged.
• Water jet holes of spray arms blocked.
• Spray arms' rotation obstructed by utensils.
• Unsuitable program selected.
"code.
• No error message.(See page 19.)
22
Advertisement
Table of Contents
