Specifications - BBT PHD-71CC Owner's Manual

Warm Engine Start
1. Open fuel cap vent screw all the way (anti-clockwise).
2. Move choke lever to CHOKE or ON position.
NOTE: CHOKE position is defined by moving the choke
lever as far to the ON position as possible.
3. Continue with Step 5 of Cold Engine Starting.
CAUTION
Avoid injury! Always handle fuel in a well ventilated
area, outdoors, away from flames or sparks.
Avoid injury! Do not start engine if fuel is spilled. Wipe
off excess fuel and allow to dry. Remove engine from
area to avoid sparks.
Avoid injury! If auger is mounted to engine, all safety
guards must be securely on to avoid serious injury.
Avoid injury! Starter rope can cause an unanticipated
jerk towards engine. Please follow instructions to avoid
injury.
Avoid injury! Never leave engine running while
unattended. Turn off after every use.
Avoid injury! Never carry powerhead and auger
between holes while engine is running.
Model
Engine Model
Engine Type
Displacement
Max. Output
Fuel
Fuel Tank Capacity
Ignition System
Starting System
Gear Ratio
Max. Engine Speed
Clutch Engine Speed
Idle Engine Speed
Auger Speed
Spark plug type /model
Specifications subject to change without prior notice.
BBT-PHD-71CC
All manuals and user guides at all-guides.com
OPERATION
Hot Engine Start
1.
2.
3.
DO NOT attempt to start engine in the following
ways:
•
•
•

SPECIFICATIONS

XYEA50
XY1E50F-1
Forced Air-cooled 2- Stroke
71cc
2.0kW
Fuel And Oil Mixture(25:1)
0.8 L
C.D.I.
Recoil
30:1
8500 r/min
3700 r/min
2900 r/min
0-280 r/min
L7RTC/TORCH
WARNING
Avoid injury! Make sure the unit is in a stable position
before pulling the starter handle.
Avoid injury! When the unit starts to fire or run, release
the throttle control momentarily with your right hand
and return your left hand to the handlebar position
to maintain control and stability of the unit with both
hands.
Open fuel cap vent screw all the way (anti-clockwise).
Continue with Step 5 of Cold Engine Starting.
If engine does not fire, refer to Step 2 of Warm Engine
Starting.
DO NOT use starting fluid.
DO NOT spray flammable liquids or vapours into air
filter, carburettor or spark plug chamber.
DO NOT remove spark plug and pull on starter rope.
Flammable fuel can spray out & ignite from a spark from
spark plug.
WWW.BBTA.COM.AU 11