NOTE: If you set all booting
options to the same device (say,
Hard Disk C), then the notebook
will try to boot from that device
only.
Setup Configuration Utility 5-4
Fast Boot
The "Fast Boot" item, when enabled, speeds up the booting
procedure by bypassing the memory test.
When this item is selected, no submenu will display. A check mark
(
) indicates Enabled; an underline ( _ ) indicates Disabled.
The default setting is Enabled.
Boot Sequence
The "Boot Sequence" item sets the sequence of booting.
When this item is selected, the submenu will display as shown below.
Boot Sequence
st
1
Boot Device
( ) Hard Disk C
( ) CD-ROM Drive
( ) Diskette A
nd
2
Boot Device
( ) Hard Disk C
( ) CD-ROM Drive
( ) Diskette A
The default setting is Diskette A ! Hard Disk C ! CD-ROM Drive.
Display Mode
The "Display Mode" item sets the display mode in your system.
When this item is selected, the submenu will display as shown below.
Display Mode
Video Display Select
( ) Auto
( ) LCD Only
( ) Simultaneously
rd
3
Boot Device
( ) Hard Disk C
( ) CD-ROM Drive
( ) Diskette A
My Presario – Getting Started