Advertisement
Quick Links
Advertisement
Related Manuals for Dante BLUESTREAM DA44AU
Summary of Contents for Dante BLUESTREAM DA44AU
- Page 1 DA44AU User Manual RevA3_User_Manual_DA44AU...
- Page 2 Panel Descriptions adjusting this product. Please keep this manual for future reference. Audio Input Settings Dante® Controller 05 - 06 Advanced Dante® Settings Surge protection device recommended. Product Schematic This product contains sensitive electrical components that may be RS-232 Control Port damaged by electrical spikes, surges, electric shock, lightning strikes, etc.
- Page 3 DA44AU USER MANUAL Introduction Our DA44AU is a four input / four output Dante® digital audio converter. The DA44AU allows any non-Dante® audio source such as mixing consoles, amplifiers, computers and Blustream Matrix products or distribution products to be connected as an audio source within a Dante® network, as well as converting a Dante®...
- Page 4 Power Port – Use included 12V/1A DC adaptor to power the device Dante® Network Ports - 2 x RJ45 sockets to connect to Dante® network, note the DA44AU will only allow 1 network connection at a time, the device does not have two independent network interfaces. The 2nd RJ45 is for redundancy but can also be cascaded to additional DA44AU units (up to 7 x devices) RS-232 Port –...
- Page 5 -10dB Line Dante® Controller Dante® Controller software is required in order to setup and configure the DA44AU as well as control your Dante® network. Audinate provide extensive training videos and documentation on their website. This can be found here: http://www.audinate.com/products/software/dante-controller Upon connecting your DA44AU to a compatible network, the Dante®...
- Page 6 Here we can adjust the sample rate of the DA44AU. Please Note: That Dante® products can only transmit or receive audio from other Dante® products that are set up with the same sample rate. A mismatch in sample rate may stop audio from transmitting.
- Page 7 DA44AU USER MANUAL contact support@blustream.com.au support@blustream.co.uk RevA3_User_Manual_DA44AU...
- Page 8 DA44AU USER MANUAL RS-232 Control Port The DA44AU can be controlled via a 3-pin Phoenix to serial RS-232 cable. The communication settings and commands are as follows: Baud Rate: 57600 bps Data Bit: 8-bit Parity: None Stop Bit: 1-bit Flow Control: None RS-232 COMMAND DESCRIPTION...
- Page 9 Power Supply: 12V/1A DC Package Contents • 1 x DA44AU • 1 x User Manual • 1 x Mounting Kit • 1 x 12V/1A DC Power Supply Acknowledgements Dante® is a registered trademark of Audinate Pty Ltd. contact support@blustream.com.au support@blustream.co.uk RevA3_User_Manual_DA44AU...
- Page 10 DA44AU USER MANUAL Installer Notes: www.blustream.com.au www.blustream.co.uk...
- Page 11 DA44AU USER MANUAL Installer Notes: contact support@blustream.com.au support@blustream.co.uk...
- Page 12 www.blustream.co.uk www.blustream.com.au...