Samsung QE55Q60AA E-Manual page 196

The problem
The message "Connecting
to Anynet+ device..." or
"Disconnecting from Anynet+
device" appears on the screen.
The Anynet+ device won't play.
The connected device is not
displayed.
You cannot use the remote control when the TV is configuring Anynet+ or switching
to the TV viewing screen.
Use the remote control after the TV has completed the Anynet+ configuration or has
switched to the TV viewing screen.
You cannot use the play function when
Check whether the device supports Anynet+.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC)
• Settings
Scan for Anynet+ devices again.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
- 196 -
Try this!
Reset is in progress.
and see if Anynet+ (HDMI-CEC)
General External Device Manager
has been set to On.
Anynet+ (HDMI-CEC)