Table of Contents
Advertisement
is adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid indicator appears
on the display of your machine.
End of programme
C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine. This
audible signal will warn you with
certain intervals before it turns
off.
C
End of Programme indicator
will light up when the washing
programme is over (Depends on
the model).
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the
socket.
C
For energy saving, the machine is
automatically turned off following
the completion of the programme
or if the programme is not started.
C
Leave your dishes in the machine
for about 15 minutes to allow
them cool down after they are
washed. Your dishes will dry in a
shorter time if you leave the door
of your machine ajar during this
period. This process will increase
the drying effectiveness of your
machine.
Water cut-off warning
If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and E:02 icon will
flash on the programme indicator.
As long as the problem continues,
washing programme is paused and
the water inlet is checked regularly
by the machine; when the water is
restored E:02 icon will disappear after
a while and the washing programme
resumes.
Overflowing warning
If the machine intakes too much
water or there is leakage at any of
the components then the machine
will detect this and E:01 icon will flash
on the Programme indicator. As long
as the overflowing continues safety
algorithm will be active and try to
discharge the water. If overflowing
stops and safety is assured, E:01
icon will disappear. If E:01 does not
disappear, there is a permanent fault.
In this case the authorised service
should be contacted.
29 EN
Advertisement
Table of Contents
