Table of Contents
Advertisement
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your electricity
supply.
Rating label is on the left hand side of fridge inner liner.
WARNING: When positioning the appliance ensure the supply cord is not trapped or
damaged.
We recommend that this appliance is connected to the mains supply via a suitable
switched and fused socket in a readily accessible position.
Should the mains lead of the appliance become damaged or should it need replacing at
any time, it must be replaced by a special purpose made mains lead which can only be
obtained from a Beko Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and
an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord
could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be
replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until
a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be
the same colour as that visible on the pin face of the plug. Fuse covers are available from
any good electrical store.
WARNING: Do not locate extension sockets or charging transformers/power supplies or
Lithium-Iron battery operated products adjacent to the compressor as they could overheat.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying
the terminals in your plug proceed as
follows:
(See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with the
symbol
or coloured green and
yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main
fuse box. If in doubt contact a qualified electrician.
3
Advertisement
Table of Contents
