Table of Contents
Advertisement
3.10
TRANSPORTING
TRANSPORT SAFETY
1. Make sure you are in compliance with all
local regulations regarding transporting
equipment on public roads and highways
including lights, refl ectors and the SMV.
2. Maximum transport speed for implement is
20 mph (32 kph). DO NOT EXCEED. Never
travel at a speed which does not allow
adequate control of steering and stopping.
Reduce speed on rough roads and surfaces.
3. Do not allow anyone to ride on the imple-
ment or tractor during transport.
4. Sudden braking can cause a towed imple-
ment to swerve and upset.
5. DO NOT tow a load that is more than double
the weight of the tractor.
When transporting the machine, review and fol-
low these instructions:
1. Be sure all bystanders are clear of the ma-
chine.
2. A safety chain will help control towed im-
plement should it separate from the tractor.
DO NOT use safety chain for towing.
3. Be sure you have installed extra weights on
the tractor if required.
4. Clean the SMV emblem, lights and refl ec-
tors and be sure they are working. Comply
with all local regulations.
5. Carry implement low when moving or
transporting.
6. Stay away from overhead power lines. Elec-
trocution can occur without direct contact.
7. Be sure your machine can clearly be seen by
overtaking and oncoming traffi c.
8. Do not allow riders.
9. Always use hazard fl ashers on the tractor
when transporting unless prohibited by law.
20
3.11
STORAGE
STORAGE SAFETY
1. Store the unit in an area away from human
activity.
2. Do not permit children to play on or around
the stored machine.
3. Store the unit in a dry, level area. Support
the frame with planks if required.
After the season's use, the machine should be
thoroughly inspected and prepared for storage.
Repair or replace any worn or damaged compo-
nents to prevent any unnecessary down time at
the start of next season. To insure a long, trou-
ble free life, this procedure should be followed
when preparing the unit for storage:
1. Clear the area of bystanders, especially
small children.
2. Thoroughly wash the machine using a pres-
sure washer to remove all dirt, mud, debris
and residue.
3. Inspect the Disc and frame for damage or
entangled material. Repair or replace dam-
aged parts. Remove all entangled material.
4. Touch up all paint nicks and scratches to
prevent rusting. Spray the cutting blades
with a rust inhibitor or paint to prevent
rust.
5. Inspect all bearings for wear. Replace any
worn out bearings.
6. Select an area that is dry, level, free of de-
bris and away from human activity.
7. Inspect all nuts for tightness. Torque loose
nuts to correct torque value.
7. If the machine cannot be placed inside,
cover with a waterproof tarpaulin and tie
securely in place.
9. Replace any decals that are worn or dam-
aged.
10. Do not allow children to play on or around
the stored implement.
Advertisement
Table of Contents
