In order to get the most out of your new SmartBoom PRO Headset, please take a few moments to read this manual completely so that you better understand the operation of this product. This document applies to models PHS-SB110, PHS-SB110E, PHS-SB210, and PHS-SB210E in the available connector options.
What’s included with SmartBoom PRO? Each SmartBoom PRO headset comes complete with everything needed to get started. Unpack your device and familiarize yourself with the following components: • Headset (assembled with ear and head pads) • Removable connector cable (arrives attached to headset) •...
Page 4
SmartBoom Mic Mute: During operation, swiveling the boom up above the brow at approximately 45 degrees will mute the microphone. To activate the microphone again, simply lower the boom back down. Mute/Unmute at 45 Figure 4: SmartBoom Mute On/Off Note: To adjust the boom, swivel it so that the microphone is on the preferred side (right or left).
Cable Clip Installation: Gently stretch the clip loops to separate them. Insert the XLR headset connector through the middle loop of the cable clip. Once installed, use the clip’s magnets to secure the headset cable to the user’s shirt for more comfortable cable management.
Page 6
Dual Mini (3.5 mm TRRS) PHS-SB110E-DMG, PHS-SB210E-DMG *Notice about Specifications: While Pliant makes every attempt to maintain the accuracy of the information contained in its product manuals, that information is subject to change without notice. Performance specifications included in this manual are design-centered specifications and are included for customer guidance and do facilitate system installation.
Product Support Pliant Technologies, LLC support and service personnel are ready to help you with any issues you may have. All requests and questions should be directed to our Customer Service department via phone, fax, or email.
All headsets and accessories (including Pliant-branded batteries) carry a one-year warranty. The sole obligation of Pliant Technologies, LLC during the warranty period is to provide, without charge, parts and labor necessary to remedy covered defects appearing in products returned prepaid to Pliant Technologies, LLC.
Need help?
Do you have a question about the SmartBoom PRO and is the answer not in the manual?
Questions and answers