Troubleshooting - Chicago Electric 66910 Set Up And Operating Instructions Manual

tO PREVEnt SERIOuS InJuRy FROM aCCIDEntal OPERatIOn
OR ElECtRIC SHOCK:
turn the Power Switch (42) of the Chipper Shredder to its "OFF" position and
unplug the unit from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
Problem
Chipper Shredder will not
start.
no cutting action.
Motor sounds as if it is not
running properly. Circuit
Breaker (39) trips.
Chipper Shredder shuts off for
no apparent reason.
SKU 66910 For technical questions, please call 1-800-444-3353.

tROuBlESHOOtIng

Possible Cause(s)
1. No power at outlet.
2. Power Cord (37) not
connected.
Circuit Breaker (39) has
3.
tripped.
4. Knobs (11) are loose.
1. Unit is clogged with debris.
Blades dull or damaged.
2.
Unit is clogged with debris.
Knobs (11) are loose.
likely Solution(s)
1. Check power at outlet.
2. Check that Power Cord (37) is
plugged in.
3. Clean debris inside Hopper
(1), Main Housing (14), and
Chute (67). Tighten Knobs
(11) firmly*. Then reset circuit
breakers and restart.
4. Check that Knobs (11) are
firmly tightened*.
1. Clean out all debris from unit.
2. Replace damaged blades.
Clean out all debris from unit.
Clean out all debris from unit.
Check that Knobs (11) are firmly
tightened*. Then restart.
*nOtE: The vibration of the unit
during normal use will cause
the Knobs to loosen and allow
the Main Housing (14) to lift up
off the Safety Shut-Off Switch
(55), turning off the Motor (47)
for safety. Tightening the Knobs
firmly will engage the Safety
Shut-Off Switch and allow the
unit to again start and run.
Page 13