Table of Contents
Advertisement
Tip: You can remove the metal residue that remains
when some items of cookware are moved on the pan
support by cleaning it properly.
→ "Cleaning the pan supports", Page 9
5 Accessories
You can buy accessories from the after-sales service,
from specialist retailers or online. Only use original ac-
cessories, as these have been specifically designed for
your appliance.
Accessories vary from one appliance to another. When
purchasing accessories, always quote the exact
product number (E no.) of your appliance. → Page 11
Accessories
Additional espresso maker
grid
Simmer plate
6 Basic operation
6.1 Igniting a gas burner
The hob has automatic ignition of the burners.
WARNING ‒ Risk of fire!
Escaping gas may ignite.
If the burner does not ignite after 15 seconds, turn
▶
the control knob to the "Off" position and open the
door or window in the room. Wait at least one
minute before igniting the burner again.
In the event of the burner flames being accidentally
▶
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one
minute.
Press the control knob for the selected burner and
1.
turn it anti-clockwise to the highest level.
Keep the control knob pressed in.
a For all of the burners, sparks are generated and the
flame ignites.
Wait a few seconds and release the control knob.
2.
→ "Safety system", Page 7
Turn the control knob to the required position.
3.
4.
If the burner does not ignite, turn the control knob to
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Description
You can find out which accessories are available for
your appliance in our catalogue, in the online shop or
from our after-sales service.
www.siemens-home.bsh-group.com
Using the appliance
¡ Only use on the burner with the lowest
power setting.
¡ Use with cookware with a diameter smal-
ler than 12.
¡ For cooking on a low heat.
¡ Use the economy burner or the standard-
output burner. If there are several stand-
ard-output burners, it is preferable to use
the rear or front-right burner.
¡ Place it on the pan support with the
bumps facing up – never place it directly
on the burner.
Note:
Take the following information into account to ensure
that the appliance works correctly:
¡ The burner parts → Page 6 and the pan supports
→ Page 6 must be inserted correctly.
¡ Do not swap the burner caps around.
¡ It is important to keep the appliance clean. Clean
the ignition plugs regularly with a small, non-metallic
brush. Take care to prevent the ignition plugs from
suffering any heavy knocks.
¡ The burner holes and grooves must be clean to en-
sure a correct flame.
→ "Cleaning the burners", Page 9
6.2 Safety system
The safety system (thermocouple) interrupts the flow of
gas if the burners accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
Ignite the burner without releasing the control knob.
1.
a The flame ignites.
Press and hold the control knob for a further four
2.
seconds.
Accessories en
7
Advertisement
Table of Contents
