Grizzly H5749 Instruction Sheet

To install the laser guide on the Model G0524
Rip Saw:
1. Disconnect the Model G0524 Rip Saw
from the power source!
Attach the steel arm to the head casting with
2.
the (4) M8-1.25 x 25 cap screws, (4) 8mm
flat washers, and (4) M8 lock washers.
Note—The mounting location and drill
pattern for the steel arm are shown on the
parts diagram. The holes must be drilled and
tapped to accept M8-1.25 threads.
Mount the laser bracket to the top of the steel
3.
arm with the (2) M6-1 x 16 cap screws and
(2) 6mm flat washers.
Place the laser clamp around the laser and
4.
secure the assembly to the laser bracket with
the (2) M6-1 x 35 cap screws.
5. Attach the black power box to the rip saw
with the (2) M5-8 x 8 Phillips head screws.
Note—Make sure the loose end of the green
ground wire is secured between the head of
the Phillips screw and the black power box.
6. Route the power wires from the power box
through the side of the saw base and into the
electrical panel compartment.
7. Connect the R1 and T1 power wires to their
respective R1 and T1 locations on the main
terminal at the electrical panel.
Feed the laser power wire through the
8.
access holes on the steel arm, and plug the
power wire into the back of the power box.
Cut a board, turn the saw OFF, place the
9.
board against the fence, and finally, adjust
the laser beam along the freshly cut edge.
DO NOT look into the end of the laser.
Serious eye damage will occur.
INSTRUCTION SHEET
Model H5749
LASER GUIDE
INVENTORY
• Steel Arm ....................................................1
• Laser Bracket ..............................................1
• Laser Clamp ................................................1
• Laser ............................................................1
• Power Box ..................................................1
• Cap Screws M8-1.25 x 25 ..........................4
• Flat Washers 8mm ......................................4
• Lock Washers 8mm ....................................4
• Cap Screws M6-1 x 16 ................................2
• Flat Washers 6mm ......................................2
• Cap Screws M6-1 x 35 ................................2
• Phillips Head Screws M5-.8 x 8 ..................2
Steel Arm
Placement
Laser
Bracket
Figure 1. Model H5749 Laser Guide.
Figure 2. Electrical wiring.
QTY
Power Box
Laser
Clamp
Laser