Turn And Lane-Change Signals - Chevrolet Impala 2007 Impala Owner's Manual

•
Windshield Wipers. See Windshield
N
Wipers on page 153.
•
Windshield Washer. See Windshield
LQ
Washer on page 154.
For information on the headlamps, see Exterior
Lamps on page 158.

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
152
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.
To signal a lane change, just raise or lower the
lever until the arrow starts to flash. Hold it
there until you complete your lane change. The
lever will return by itself when you release it. If you
momentarily press and release the lever, the
turn signal will flash three times.
If the arrow flashes faster than normal as you
signal a turn or a lane change, a signal bulb may
be burned out and other drivers won't see
your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when
you signal a turn, check for burned-out bulbs and
then check the fuse. See Fuses and Circuit
Breakers on page 400.
Turn Signal On Chime
If you leave either one of your turn signals on and
drive more than 3/4 mile (1.2 km), a chime will
sound to alert you.