Eu Declaration Of Conformity - CarlStahl CondorGrip CGUK 1.0 t Operating Instructions Manual

Introduction

1.2 EU declaration of conformity

Content of the document:
For the product designated below
Name:
Type:
we hereby declare that it corresponds to the basic requirements specified in the harmonization legislation
named below:
DIRECTIVE 2006/42/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of May 17, 2006 about
machines and the change of Directive 95/16/EC (new version) – in short: Machinery Directive
Specification of the applicable harmonized standards that apply or details of the specifications for which
conformity is declared:
Reference
Harmonized standards for the Machinery Directive:
EN ISO 12100
+ Correction 1
EN 13155
Additional applicable technical specifications (not published in the EU official gazette):
DIN ISO/TR 14121-2
DIN SPEC 33885
Authorized within the meaning of Annex II No. 1. A. No. 2, 2006/42/EC for the compilation of the technical
documents:
Company
Address
Sole responsibility for issuing this declaration of conformity with regard to meeting the basic requirements and
the preparation of the technical documents is borne by the manufacturer (or installation company):
Company
Address
Declared by:
Last name, first name
Title
This declaration certifies conformity with the named harmonization legislation, however it does not promise
properties.
Additional details:
This declaration applies to all copies that are manufactured according to the corresponding production
drawings, which are a component of the technical documents. The attached accompanying documentation that
supports the declaration of conformity contains additional details about adherence to above references.
The complete declaration of conformity is attached as a separate document.
www.carlstahl.com
CondorGrip sheet metal lifting clamp
CGUK
Date of issue Title
2010-11 Safety of machines – General principles for
2013-08 design – Risk assessment and risk reduction
2022-03 Cranes – Safety – Non-fixed load lifting
attachments
2013-02 Safety of machinery - Risk assessment - Part 2:
Practical guidance and examples of methods
Carl Stahl Hebetechnik GmbH
Tobelstr. 2
D-73079 Suessen
Carl Stahl Hebetechnik GmbH
Tobelstr. 2
D-73079 Suessen
Schwenger, Wolfgang
Managing director
- 2 -