Hoymiles DTU-W100(3Gen) Quick Installation Manual

1. Interface Layout

Item
A
B
C

2. Preparation

A) Download the Hoymiles Mobile Installer
App.
B) Check the box for the following items:
- Hoymiles DTU-W100
- Adapter

3. Installation

A) Power the DTU-W100 3rd Gen
Option 1: Connect the DTU to the
adapter and plug it into the wall
socket.
Option 2: Connect the DTU to the
adapter and plug it into the power
strip. Please make sure that it is
placed at least 0.5 meters above the
ground, and try to install the DTU at a
90 degrees angle perpendicular to the
ground.
Note: Please do not install the DTU directly above metal or concrete to prevent signal interference.
B) Start Procedure.
Once the DTU powers on, the red, green and blue lights will flash in sequence for one second each for 30 seconds.
C) Set up with Internet.
Use the smartphone/tablet to open the
Installer App and login. Locate "O&M" on
the bottom of the page, select "Network
Config", and then complete the Wi-Fi
configuration.

4. Installation Map

Complete the installation map.
A) Peel the serial number label (as circled
below) from the DTU and place it on the
installation map.
Region: Global AP040259 REV1.2
Description
USB Connector
Status Indicator
Reset Button
© 2020 Hoymiles Power Electronics Inc. All rights reserved.
DTU-W100(3Gen) Quick Installation Guide
01