Kohler Finial K-316 Installation And Care Manual page 3

1.
Install the Spray Assembly
Bidet/Bidet/Bidet
Nut/Écrou/Tuerca
Remove the spray head and flange.
Thread the nut, metal washer, and rubber washer to the bottom of the shank.
Apply a ring of plumbers putty or other sealant to the bottom of the flange
according to the putty manufacturer's instructions.
From the underside of the bidet, insert the shank through the spray hole.
From the top of the bidet, thread the flange onto the shank.
NOTE: You may need to thread the flange further down the shank to allow the spray
head to bottom out on the shank.
Thread the spray head onto the shank as far as it will go.
Thread the flange up the shank until it is snug against the spray head.
Wrench tighten the nut to secure the spray head assembly. Do not overtighten.
Remove any excess putty or sealant.
Kohler Co.
Spray Head
Tête du vaporisateur
Cabeza del rociador
Flange/Bride/Brida
Shank/Tige/Vástago
Rubber Washer
Rondelle en caoutchouc
Arandela de goma
Metal Washer
Rondelle métallique
Arandela de metal
3 1144567-2-A