Tools Required - Inalto FUORI IBBQBI6B User Manual

PAGE 15
NATURAL GAS CONVERSION
WARNING
1 Conversions only to be done by an Authorized person
2 A restraining tether or bracket is required to be fixed
to the appliance and to the wall within 50mm of
each connection point. The length of the tether shall
not exceed 80% of the length of the natural gas hose
assembly.

TOOLS REQUIRED

1 Socket head screw driver (Included with the product)
2 Wrench
GAS PIPING
1 A minimum pipe with diameter 15mm is required for
inlet piping. A lever operated shut-off valve should be
installed within 1 meter of the appliance for servicing
the appliance.
2 Where it is not practical to install solid copper pipe to
AS/NZS 5601.1, hose assemblies certified to AS/NZS 1869
or limited flexibility connectors certified to AS 4631 may
be used.
The internal diameter of the hose must not be less than
10mm. The hose should be as short as practicable in
accordance with AS/NZS 5601.
3 All gas pipe connections must be sealed with a gas pipe
compound resistant to natural gas. Remove LPG hose
and regulator and ensure that a Natural Gas regulator
(not supplied with the appliance) is used.
NOTE TO INSTALLERS
► For main burner, the U-LPG jet is 0.98mm, the NG jet is
1.50mm
► For back burner, the U-LPG jet is 0.98mm, the NG jet is
1.65mm
► Both U-LPG injector and NG injector are installed
together like right photo shows. The BBQ is set for
U-LPG by manufacturer.
JET FOR NG
Jet for LPG
INALTO.HOUSE
1 Test operation of appliance such as leak-tightness,
burner flames at high and low, and instruct user on safe
operation before leaving.
2 If the appliance cannot be adjusted to perform correctly
contact your distributor or the manufacturer for
assistance.
INSTRUCTIONS FOR CONVERTING THE MAIN BURNER
1. Unscrew and remove the rear panel pictured.
2. Unscrew the main burner securing screws and
remove the burner, sitting it alongside.
（1）
（2）