Vizio SB3851-D0 Quick Start Manual page 26

Function
TV Remote
VZtv Rmt On
Program Remote
Prg Remote
Eco Power On/Off
EcoPwr
Speaker Test
Spkr Test
Link
Link On
Reset
Reset No
When a Dolby
Digital or DTS
signal is detected.
English - 26
LED Behavior
Press the Next/Previous button to enable/disable VIZIO TV Remotes. When en-
TV Remote On
abled (On), you can use a VIZIO TV remote control to turn on the sound bar (using
TV Remote Off the TV Volume Up button) and control volume.
Press the Next/Previous and Play buttons to toggle and select and program
−− your TV remote to control the Volume Down, Volume Up, and Mute functions
on your sound bar. See the Program Remote section for more information.
Press the Next/Previous button to enable/disable Eco Power Mode. When enabled
Eco Power On
(On), the sound bar will go into standby after a period of inactivity. The sound bar will
automatically turn off when no audio signal is detected. Off disables this feature.
Eco Power Off
Note: Enable this function if using a TV remote to control the sound bar or if you
would like to cast content with need to manually turn on the sound bar.
Press the Play/Pause button to activate the speaker test function. A voice will
begin calling out each speaker beginning with left front . (Left Front, Center,
— Right Front, Right Rear, Left Rear, and Subwoofer-white noise) If any of these
are
missing, check the connection and run the speaker test function again.
Press the Next/Previous and Play buttons to select and confirm enabling or
Single light with sound
disabling Link Mode on your sound bar. Link Mode allows the VIZIO SmartCast
upon confirmation
App to reconnect the sound bar to Wi-Fi in the event of a lost connection or if a
new device is being paired.
Press the Next/Previous and Play buttons to select and reset your remote and
sound bar to the factory default settings. All paired Bluetooth devices will be un-
−−
paired. All programmed IR remotes will also be removed. See the Reset to Factory
Default Settings section for more information.
Dolby Digital and DTS are only available on either the Coaxial In or
Dolby Digital and DTS
Digital Optical Audio In inputs. When a Dolby Digital or DTS signal is detected,
Indicator LED
the Dolby Digital (White) / DTS (Amber) indicator LED will light up for 5 seconds
before fading away.
Description