Table of Contents
Advertisement
ADJUST BELT TENSION
Refer to Figure 16
The drill spindle speed is determined by the position of the
belts on the pulleys inside the head assembly.
• To unlock the belt tension, turn the belt tension lock
knob on the right side of the drill press head
counterclockwise.
• Pull the motor toward the front of the drill press to
loosen the belt tension.
• Position the belt on the correct pulley steps for the
desired speed.
• Push the motor away from the drill press head until the
belt is properly tensioned.
• Belt tension is correct if the belt deflects approximately
1/2 inch when pressed at its center.
• Tighten the belt tension lock knob to secure the motor in
position.
8
WARNING
Turn the switch to "OFF" position and disconnect
the machine from power source before servicing or
disassembling any components.
CLEANING
• Keep machine and workplace clean. Avoid accumulation
of sawdust on the tool.
• Be certain motor is kept clean and free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
Figure 16
MAINTENANCE
LUBRICATION
• A light coat of paste wax on the work table will make it
easier to feed the workpiece and prevent rust.
KEEP TOOL IN REPAIR
• If power cord is worn, cut or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use
parts listed to order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
• Call the customer line at 1-877-393-7121.
Belt Tension
Lock Knob
Advertisement
Table of Contents
