3.
Attach the cabinet (outer) member to the rail.
Insert the stag into the upper and lower square holes on EIA rail from the back
of rail. Push the safety lock forward to secure the bracket. It is important to
check if the safety lock is in unlocked position before mounting the brackets.
4.
Mount the chassis into the cabinet.
Insert the chassis (inner) member into the cabinet member as shown on the
drawing. It is important to check if the ball retainer is in fully open position before
install the chassis. It might cause catastrophic damage to the chassis if ball
retainer is not in fully open position while mounting the chassis. While you are
pushing chassis back to the cabinet, you need to release the slide from locking
position by pressing the trigger down.
31
AGS-913 Series User Manual