Test Run; Mounting - Grizzly G7945 Owner's Manual

Test Run

Once assembly is complete, you are ready to test
run the drill press.
Wear
whenever
using machine. Failure
to comply may result in
serious personal injury.
Keep
rolled up and out of the
way of machinery and
keep hair pulled back.
To test run the drill press:
1. Turn the power supply ON at the main
panel.
2.
With your finger poised on the paddle
switch (in case there is a problem), flip the
START button ON. The drill press should run
smoothly, with little or no vibration or rubbing
noises.
Investigate and correct for strange or unusual
noises before operating the machine further.
If you cannot easily locate the source of a
potential problem, refer to Troubleshooting
on Page 33. If you still can't solve the
problem, contact our Technical Support at
(570) 546-9663.
-20-
safety glasses
starting or
loose clothing

Mounting

The Model G7945 should be secured to a bench.
The Model G7946 base should be secured to the
floor.
Bench Mounting
Components and Hardware Needed:
Assembled Drill Press ........................................1
⁄ " Mounting Hardware (Not Included) .......Varies
1
2
To mount the G7945 drill press to a table:
1. Clamp the base on a bench top capable
of holding approximately 100 lbs. plus the
weight of the workpiece using two clamps.
Make sure the surface is flat and stable.
2. Using holes in the base as a guide (Figure
15), drill and bolt the base to the bench top
using ⁄ " lag bolts, or hex bolts, flat washers,
1
2
and hex nuts.
Mounting
Holes
Figure 15. Using holes as a drilling guide.
G7945/G7946 Radial Drill Press
Qty