Advertisement
The manual provides the correct instructions for installation, use and mainte-
nance, as well as giving useful advice.
For Great Britain only
Warning: this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is fit-
ted with a BS 1363A 13amp fused plug,
to change a fuse in this type of plug use
an A.S.T.A. approved fuse to BS 1362
type and proceed as follows:
1. Remove the fuse cover (A) and
fuse (B)
2. Fit replacement 13A fuse into
fuse cover
3. Refit both into plug
Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover is
lost the plug must not be used until a correct replacement is fitted.
Correct replacement are identified by the colour insert or the colour embossed
in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
If the appliance is provided with a plugless supply cord:
It is necessary to install in the fixed wiring an all-pole disconnection device
having a gap between contacts of at least 3,5mm. After installation the
disconnection device has to be easy to reach.
The connection to the mains must be carried out by a qualified technician
in accordance to the scheme shown below and the regulations in force
In the event of damage to the supply cord, it has to be replaced by the
manufacturer or an authorized technical service center in order to avoid
any risk.
The manufacturer declines all responsibility for injury or damage caused
by failure to comply with the above regulations or deriving from tampering with
even just one part of the appliance and the use of non-original spare parts.
EN
L = brown
N = blue
= yellow-green
6
Advertisement
