Download Print this page

Troubleshooting - Smeg LSIA127 Instruction Manual

Advertisement

7. TROUBLESHOOTING

This produce complies with the relevant regulations governing the safety of electrical equipment. For safety reasons,
any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user.
If the appliance does not work, before calling the After-Sales Service, to avoid unnecessary expense, check yourself
that the operations listed in this troubleshooting table have been carried out.
1
Appliance does not start
2
No water filling
3
No water visible in washing
drum
4
Water not pumped out
5
Water not pumped out after
last rinse in delicate fabrics
and
wool
grammes
6
Water takes in and pumps
out water continually
7
Strong
vibrations
spins
8
Too much foam formed in
tank and flowing out of
drawer
9
Water on floor
10
Not all fabric conditioner
used or too much water left
in compartment
Check that:
- plug is properly connected to socket
- door is securely closed
- "Start/Pause" button has been pressed.
Check that:
plug is properly connected to socket
-
-
door is securely closed
-
water tap is turned on
-
water intake hose filters not fouled.
-
water intake hose not trapped or kinked.
No malfunction.
The water level is below the level of the glass in the door because new
appliances use very little water to achieve the same washing and rinsing
results.
Check that:
-
drain hose is not kinked
drain pump not fouled.
-
It is not a malfunction: pause programmed into washing programme to pre-
vent creasing of fabrics.
wash
pro-
To pump out water, proceed as described in "Programme End" point.
Check that end of drain hose is not too low down.
during
Check that:
Appliance is properly levelled
-
-
washer-dryer not too close to walls or kitchen units
-
internal unit on flexible mounts locked in position.
Check that:
-
detergent used is recommended for automatic washing machines and
not for hand washing
-
quantity used is as stated in manual and no more.
Check that:
water intake hose fittings not loose
-
end of drain hose still correctly positioned.
-
Check that detergent drawer siphons are correctly fitted and not fouled.
EN
.
28

Advertisement

loading