Advertisement
Table of Contents
OWNER'S MANUAL
FX9600M
Big Button Telephone
OPERATION AND MAINTENANCE
ASSEMBLY INSTRUCTIONS
Note:
If you have high speed internet without a central splitter you may need an ADSL filter between
the phone and the wall jack point. The typical symptom of a jack point requiring a filter is loud
static and hissing sounds in the earpiece (check other telephones devices on this line, if they
have a filter installed then this jack point will need one as well)
As you add more telephones or telephone devices to your wiring, ringing can sometimes become
intermittent on some or all connected devices as the maximum loading is reached.
1.
Remove the leads from the packaging. The handset curly cord and the cable that connects your phone
to the wall socket must be connected correctly or the telephone will not operate.(SEE PICTURES
BELOW)
2.
Plug the curly cord into the handset socket fully.
3.
Plug the other end of the curly cord into the socket located on the left-hand side of the telephone.
4.
Plug the telephone line cable to the left hand socket located on the top edge of the telephone, (the one
nearest to the ringer switch) and connect the plug to your telephone jack point.
DATA PORT SOCKET
This socket is paralleled with the incoming telephone socket and allows you to connect many types of equipment
to your Telephone. It is suitable for most modern two wire devices. E.G. caller display, Answering Machines,
Computer Modems, Cordless Telephones, Extension Ringers. Note: Telepermitted equipment only should be
connected to the Data Port. The Data Port is not specifically designed for 3 wire connected equipment. 3 wire
equipment connected to it may not respond to incoming ringing when attached to this port
NOTE CORRECT CORD POSITIONS
DESKTOP USE
(factory default as shipped)
LINE CORD
HANDSET CORD
Handset wall clip with smooth side
uppermost
FOR DESKTOP USE
Wall mount bracket removed
Advertisement
Table of Contents
Related Manuals for Custom Audio Electronics FX9600M
Summary of Contents for Custom Audio Electronics FX9600M
- Page 1 OWNER’S MANUAL FX9600M Big Button Telephone OPERATION AND MAINTENANCE ASSEMBLY INSTRUCTIONS Note: If you have high speed internet without a central splitter you may need an ADSL filter between the phone and the wall jack point. The typical symptom of a jack point requiring a filter is loud...
- Page 2 WALL MOUNTING Clip the bracket supplied to the rear of your telephone to keep the phone on the correct angle when wall mounting. IMPORTANT. Locate the handpiece locking tab on the main body of the telephone just below the hook switch. Slide up this tab and reinstall it with the tongue protruding. This tongue hooks into the handpiece when wall mounting to prevent the handset falling.
- Page 3 DIALLING To make a call, lift the handset, listen for the dial tone and press the appropriate buttons for the number you require. STORE a Number in memory To store a number, lift the handset, press “STORE”, and dial the number that you wish stored. Then press STORE again and the address where you wish the number stored.
- Page 4 FAULTS If your telephone is failing to make call or ring: Make sure the leads are connected correctly. Make sure that all handsets on all telephones are properly “hung up” Try a different telephone in the same wall socket. Try the same telephone in other wall sockets. Try any other combination including having only one telephone connected at any one time.
Need help?
Do you have a question about the FX9600M and is the answer not in the manual?
Questions and answers