Custom Audio Electronics FX9400H Owner's Manual

OWNER'S MANUAL
FX9400H
Speaker Phone
OPERATION AND MAINTENANCE

ASSEMBLY INSTRUCTIONS

Note:
If you have high speed internet without a central splitter you may need an ADSL filter between
the phone and the wall jack point. The typical symptom of a jack point requiring a filter is loud
static and hissing sounds in the earpiece (check other telephones devices on this line, if they
have a filter installed then this jack point will need one as well)
As you add more telephones or telephone devices to your wiring, ringing can sometimes become
intermittent on some or all connected devices as the maximum loading is reached.
1. Remove the leads from the packaging. The handset curly cord and the cable that connects your phone
to the wall socket must be connected correctly or the telephone will not operate.(SEE PICTURES
BELOW)
2. Plug the curly cord into the handset socket fully.
3. Plug the other end of the curly cord into the socket located on the left-hand side of the telephone.
4. Plug the telephone line cable to the left hand socket located on the top edge of the telephone, (the one
nearest to the ringer switch) and connect the plug to your telephone jack point.
DATA PORT SOCKET
This socket is paralleled with the incoming telephone socket and allows you to connect many types of equipment
to your Telephone. It is suitable for most modern two wire devices. E.G. caller display, Answering Machines,
Computer Modems, Cordless Telephones, Extension Ringers. Note: Telepermitted equipment only should be
connected to the Data Port. The Data Port is not specifically designed for 3 wire connected equipment. 3 wire
equipment connected to it may not respond to incoming ringing when attached to this port
NOTE CORRECT CORD POSITIONS
(factory default as shipped)
DESKTOP USE
LINE CORD
Handset Cord
Handset wall clip with smooth side
uppermost
FOR DESKTOP USE
Wall mount bracket removed