Advertisement
Available languages
Available languages
EN
I. Opera on mode
50W, 100W, 200W, 300W:
•
The solar charging me is 5-8 hours, but there are many factors to be considered, such as the loca on and temperature of the area.
• When discharging, the mode is :100% brightness in the fi rst hour, 80% brightness in the second hour, 60% brightness in the third hour, 50% brightness in the
fourth hour, 30% brightness in the fi h to sixth hour. It will remain on un l dawn where it will go into charging mode.
• Οpera ng me: 3H, 5H , 8H
• Another mode is brightness adjustment mode, which is indicated on remote control
• For best results, it is recommended to use the automa c mode "AUTO".
• Usually when the device is switched on, the automa c mode is selected by default.
• Automa c mode: The brightness of the whole lamp can be adap vely controlled according to the ba ery's own power
II. IMPORTANT SAFETY INFORMATION
• Do not dispose the ba ery in fi re. This may result in an explosion.
• Do not expose the light to fi re or intense heat as the ba ery may explode.
• Do not immerse in water.
• Never look directly into the light or shine it into another person's eyes
• Consult your local construc on guide, if needed, for installing the light fi xture in the building.
III. FIXING INSTRUCTIONS
• The light fi xture should be installed on a fl at and stable surface
• Avoid installing the light near an air condi oner, a central heater, or high voltage system
• The solar charger board should be set in a sunny area where maximum sunlight can be collected. Typically, the solar board
should face a direc on (south) where sunlight can charge the board for at least 3 hours per day (5 hours per day if behind glass)
It is suggested to charge the light for 24 hours before fi rst use
• Use a so wet cloth to periodically (at least once a year) clean the charger board to avoid the reduc on of power output due to
accumulated dust
IV. INSTALLATION
1-Fix the bracket of the solar panel.
4-Adjust the angle which you need.
3
2-Remove the bracket from the lamp body and fi x it.
5-Connect the wire of the solar panel to the wire
of the lamp.
WWW.BORMANNTOOLS.COM
3-Fix the lamp body to the bracket.
Advertisement
