Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2009 Malibu Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
This instrument panel cluster light
high beam lamps are turned on while the ignition
is in ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets the high-beam headlamps be used to
signal a driver in front of you that you want to pass.
Pull the turn signal/multifunction lever toward you until
the high-beam headlamps come on, then release
the lever to turn them off.
3-8
3 comes on if the

Windshield Wipers

The windshield wiper lever is located on the right side of
the steering wheel.
Move the lever to control the windshield wipers.
9
(Off): Turns off the windshield wipers.
& (Intermittent; Speed Sensitive Wipers): For
intermittent or speed sensitive operation. The amount
of delay time varies between wiping cycles due to the
delay setting selected or the speed of the vehicle. As
vehicle speed is increased or decreased, the wiper
interval also increases or decreases.