Advertisement
Ice storage
To remove:
bin
Lift up the access door to reach the icemaker.
Set the icemaker power switch to the OFF
position. With the access door closed, support
the storage bin at the bottom while slightly
lifting. Pull bin straight out.
To replace:
Slide the bin back until the tab on the bin locks
into the slot on the shelf. If the bin does not go
all the way back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin back
again.
Important
• Do not add ice from trays or bags to the
facts about
your ice
• Avoid overfilling glass with ice and use of
& water
dispenser
• Beverages and foods should not be quick-
• To keep dispensed ice from missing the glass,
• Some crushed ice may be dispensed even
• After crushed ice is dispensed, some water
storage bin. It may not crush or dispense well.
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in the
chute to freeze shut. If ice is blocking the
chute, push it through with a wooden spoon.
chilled in the ice storage bin. Cans, bottles or
food packages in the storage bin may cause
the icemaker or auger to jam.
put the glass close to, but not touching, the
dispenser opening.
though you selected CUBES. This happens
occasionally when a few cubes accidentally
get directed to the crusher.
may drip from the chute as small particles of
ice melt.
Ice & Water Dispenser
Built-In Refrigerators
Access Door
Ice Storage Bin
Drive
Mechanism
• Sometimes a mound of ice chips will form
on the door in the ice chute. This condition
is normal and usually occurs when you have
dispensed crushed ice repeatedly. The ice
chips will eventually evaporate.
• Dispensed water is not ice cold. For colder
water, simply add crushed ice or cubes before
dispensing water.
• The first glass of water dispensed may be
warmer than the following ones. This is
normal.
• To eliminate drips on the spill shelf, tilt the
glass in slightly when dispensing water.
(on some models)
Rotate
11
Advertisement
