Forcepoint V20000 G1 Quick Start Manual

Quick Start Guide
Forcepoint V20000 G1
Forcepoint V10000 G4R2
Web or Email Security Appliance

Before you begin...

Plan your deployment before setting up the appliance. See the
back of this guide for a deployment overview and reference sheet.
1

Verify Contents

Accessory Kit
1
Power Cables (2) Ethernet Cables (4)
Bezel (faceplate)
2 Sliding Ready Rail Kit
• Left Ready Rail
• Right Ready Rail
• Velcro Straps (2)
• Rack Installation Instructions
3 Cable Management Arm Kit
• Cable Management Arm • Cable Tie Wraps
• Static Support Tray • CMA Installation Instructions
Contact Forcepoint Technical Support if any items are missing.
Optional 10GbE NIC Expansion Kit available. Contact your Forcepoint
account representative.
Rack Appliance
2
See the Rack Installation Instructions included in the
Sliding Ready Rail kit.
©2018 Forcepoint LLC. All rights reserved.
3

Determine Security Mode

The appliance supports the following security modes:
• Web (Forcepoint Web Security)
• Email (Forcepoint Email Security)
Based on your subscription and deployment plan, determine the appropriate security mode for this
appliance.
4

Connect Network Cables

Cat 5E cables (or better) are required. Do not use crossover network cables. If optional 10GbE optical
NIC is selected, please refer to 10GbE PCI NIC Installation Guide.
Serial Cable
5 Connect Input Device
1. Connect to the appliance via serial port or KVM in order to access the command line interface for
initial configuration. Serial port settings are: 9600 baud, 8 bits, no parity.
iDRAC Serial Port
2. Secure power cables using velcro straps and plug power
cables into an appropriate power source.
KVM

Power On Appliance

6
Power on the appliance and check the following indicators:
Front
• Power button is illuminated.
• Hard drive LEDs are green.
Rear
• Power supply LEDs are green.
• LEDs for connected interfaces (NICs) are green.
• System status indicator (LED left of power supplies) is solid
blue.
Contact Forcepoint Technical Support if any indicators are not
illuminated correctly.
7

Configuration Overview

Please refer to the Forcepoint Appliances Getting Started guide
for more details.

Initial Configuration

Firstboot Script
• Configure security mode.
• Configure the appliance management communication
interface (C).
• Configure NTP servers/system time.
Appliance Command Line
• Configure applicable network interfaces.
• Configure other settings as desired.

Web Mode

Forcepoint Security Manager
• Enter subscription key, update Master Database, configure
Network Agent, and configure policies in Forcepoint
Security Manager.
• Requires Windows Server 2008 R2, or Windows Server 2012
or 2012 R2, or Windows Server 2016.
Content Gateway Manager (proxy)
• Configure user authentication and select protocols.

Email Mode

Forcepoint Security Manager
• Complete configuration wizard, enter subscription key, and
configure policies in the Email Security module. Configure
email DLP policies in the Data Security module.
• Requires Windows Server 2008 R2, or Windows Server 2012
or 2012 R2, or Windows Server 2016.
QSGV640-100_RevA