Table of Contents
Advertisement
Faults, what to do?
Faults
Water is running out.
Water not flowing in.
Dispenser is empty and
fill level display is not
flashing.
Wrong detergent/
softener has been
poured into dispenser.
Detergent/softener
congealed in the
dispensers.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not
satisfactory.
Washing wet/too damp.
Spin cycle activated
several times.
Residual water in the
dispenser for care
product.
Odour formation in the
washing machine.
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
A
– Start/Reload
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 46
– Supply hose kinked or jammed?
– Drawer cover/rear drawer plug dirty? Cleaning ~ Page 42
– Detergent drawer not inserted correctly? Insert correctly.
~ Page 34
Dispensers:
1. Drain and clean dispensers.
2. Refill dispensers. ~ Page 33
Clean and refill dispensers.
– Safety function active. Stop programme?
$
– Rinse Hold
(without final spin) selected?
– Can be opened via emergency release only? ~ Page 47
A
– Start/Reload
– Door closed?
– Childlock active? Deactivate.
$
– Rinse Hold
(without final spin) selected?
– Clean the drain pump.
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped
the spin cycle, washing unevenly distributed.
p
Distribute small and large items of washing in the drum.
– Less Ironing
– Too low speed selected?
Not a fault – unbalanced load detection system adjusts
imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert.
Run
(Cottons) 90 °C programme without washing.
Use standard detergent.
not selected?
Έ
or
(Finished in) time selected?
selected? ~ Page 23
49
Advertisement
Table of Contents
