3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
Please empty
condensate container
on the display panel and
drying has stopped.
Please clean lint filter
on the display panel.
Heat exchanger is
being rinsed on the dis-
play panel.
Dryer will not start.
¢ on the display panel. Wi-Fi is switched on but a connection to your home network cannot be estab-
Home Connect is not
working.
Creasing.
Water is leaking out.
Programme duration
displayed changes
during drying.
* Depending on the model
Cause/remedy
Empty the condensation container; ~ Page 34 and the dryer;
■
~ Page 18
If the optional condensation drain* has been installed, the drain hose may
■
be blocked or kinked. Check the hose for deposits and flush the hose
through. Lay the hose without any kinks.
Clean the fluff filter and press the Start button ~ Page 32.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensation container while this is displayed.
Mains plug plugged in or fuse/circuit breaker checked?
■
Programme selected?Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 29.
■
lished.Check whether your home network is available or try to connect to your
home network again.
You can find solutions to problems with Home Connect at www.home-con-
■
nect.com.
The availability of the Home Connect functionality depends on the availabil-
■
ity of the Home Connect Services in your country. Home Connect Services
are not available in every country – for further information please check:
www.home-connect.com.
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 27.
Remove clothes immediately after drying; creasing will occur if they are left
■
in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length accordingly (except timed programmes).
Faults and what to do about them
en
43