Frigidaire FGMC2766UDA Installation Instructions Manual

MICROWAVE/ WALL OVEN COMBINATION
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier. The
first step of your installation should be to measure your current cutout dimensions and compare them to the cutout
dimensions chart below for your model. You may find little or no cabinet work is necessary.
Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven.
These spacers center the oven in the space provided. The oven must be centered to prevent excess heat
buildup that may result in heat damage or fire.
NOTES:
1. Base must be capable of supporting 225 pounds (102 kg).
2. Allow at least 21" (53.3cm) clearance in front of oven for door
depth when it is open.
3. Dimension G (cutout depth) is
critical to the proper installation
of the built-in oven. If the
oven decorative trim does not
butt against the cabinet verify
dimension G to assure it is the
required depth.
* Suggested distance from floor
is 11½" (29.2 cm).
Minimum required distance is
4 ½" (11.4 cm)
MODEL
27" (68.8cm) Wall Oven
30" (76.2cm) Wall Oven
MODEL
27" (68.8cm) Wall Oven
30" (76.2cm) Wall Oven
All dimensions are stated in inches and (cm).
Printed in USA
INSTALLATION INSTRUCTIONS
B
Door Open
(see note 2)
A
PRODUCT DIMENSIONS
A
27 (68.6)
30 (76.2)
CUTOUT DIMENSIONS AND CABINET WIDTH
F
Min. Max.
24 / 25¼ (64.1)
7
8
(63.2)
28½ (72.4) 29 (73.7)
1" (2.5 cm)
Min.
C
H
40-4/5"
40-15/16"
(104 cm)
11½"
(29.2 cm)
Spacer
D
2" (5 cm) Wide Wood
Spacer if Needed
Figure 1
B
424/5 (108.8) 245/8 (62.5)
42¼ (107.7) 281/4 (71.8)
G. Min. Min.
23¾ (60.3) 41 / (104.5)
1
8
23¾ (60.3) 41 / (104.5)
1
8
1
United States
and Canada
Hole for
Cable
I
(right or
left side
depending
on model)
G
F
3" (7.6 cm)
1¼"
Electrical
(3.2 cm)
Junction Box
Min.
(right or left side)
C D
243/4 (62.9)
243/4 (62.9)
H
Max. I
41¼ (104.8) 27 / (68.9) Min
1
8
41¼ (104.8) 30 / (76.5) Min
1
8
P/N 807611004 (1903) Rev. B
English – pages 1-8
Español – páginas 9-16
Français - pages 17-24
Max.