Table of Contents
Advertisement
To set a self clean cycle:
1. Press Self Clean. --- appears in the display.
2. Press
until 3:00 appears in the display for a 3
hour self clean process, or push
appears in the display for a 2 hour self clean process.
3. As soon as the controls are set, the motor driven lock
will begin to close automatically and the door locked
indicator light will flash. Do not open the oven door
while the light is flashing (allow about 15 seconds for
the oven door to lock).
4. CLn will appear in the display during the self clean
cycle, and the door locked light will glow until the self
cleaning cycle is complete or cancelled and the oven
temperature has cooled.
When the self clean cycle has completed:
•
The time of day will appear in the display window, and
the Clean key and door locked light will continue to
glow.
•
Once the oven has cooled down for about 1 hour and
the door locked light has gone out, the oven door may
be opened.
•
To avoid possible burns, use care when opening the
oven door after the self cleaning cycle. Stand to the side
of the oven when opening the door to allow hot air or
steam to escape.
To stop or interrupt a self clean cycle (once it has been
activated):
1. Press OFF.
2. Once the oven has cooled down for about 1 hour and
the door locked light has turned off, the oven door can
be opened.
3. Restart the self clean cycle once all conditions have
been corrected.
Setting Delay Start Self Clean
To start a delay self clean with default clean time of 3 hours
and a start time of 9:00 o'clock: Be sure the clock is set with
the correct time of day, the oven is empty, and all oven
racks are removed. Be sure oven door is completely closed.
1. Press Start Time and
2. Press Self Clean. --- appears in the display.
3. Press
until 3:00 appears in the display for a 3
hour self clean process, or push
appears in the display for a 2 hour self clean process.
until 2:00
to 9 0 0 and release key.
until 2:00
SETTING OVEN CONTROLS
4. The motor driven lock will begin to close automatically
and the door locked indicator light will flash. Do not
open the oven door while the light is flashing (allow
about 15 seconds for the oven door to lock).
5. CLn will appear in the display during the self clean
cycle, and the door locked light will glow until the self
cleaning cycle is complete or cancelled and the oven
temperature has cooled.
Adjusting the oven temperature
Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature recommen-
dations carefully. If you think the oven is cooking too hot or
too cool for your recipe times, you can adjust the control so
the oven cooks hotter or cooler than the temperature
displayed.
NOTE
Do not use oven thermometers such as those found in
grocery stores to check the temperature settings inside
your oven. These oven thermometers may vary as much
as 20 to 40 degrees from actual temperatures.
To adjust oven temperature:
1. Press Bake.
2. Set the temperature to 550°F (287°C) by pressing and
holding
.
3. Within 3 seconds, press and hold Bake until numeric
digit(s) appear. Release Bake key. The display now
indicates the amount of degrees offset between the
original factory temperature setting and the current
temperature setting. If the oven control has the original
factory calibration, the display will read 00.
4. The temperature can now be adjusted up or down 35°F
(19°C), in 5°F (1°C) increments. Press and hold
to adjust the temperature higher until the desired
amount of offset appears in the display. When lowering
the oven temperature using
appear before the number to indicate that the oven will
be cooler by the displayed amount of degrees.
5. When you have made the desired adjustment, press
OFF to go back to the time of day display.
, a minus sign (-) will
31
Advertisement
Table of Contents
