Table of Contents
Advertisement
2. Setting up the monitor
Height adjustment
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
180mm
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
Display base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not
to scratch or damage the screen.
2. Loosen the assembly screws, then
detach the bases from the display.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
9
100mm
100mm
Advertisement
Table of Contents
