LG GF22BGS Owner's Manual page 23

23 INSTALLATION
CONNECT THE TUBING TO THE VALVLE
7
Place the compression nut and ferrule
(sleeve) for copper tubing onto the end of
valve. Make sure the tubing is fully inserted
into the valve. Tighten the compression nut
securely.
Saddle-Type
Packing Nut
Outlet Valve
FLUSH OUT THE TUBING
8
Turn the main water
out the tubing until the
water is clear.
the water valve after
a b o u t o n e q u a r t o f
CONNECT THE TUBING TO THE
9
REFRIGERATOR
NOTE: Before making the connection to
the refrigerator, be sure that the refrigerator
power cord is not plugged into the wall
outlet.
a
water valve.
b. Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
c. Insert the end of the copper tubing into the
connection as far as possible. While holding
Tubing Clamp
¼ in.
Compression
Nut
Ferrule (sleeve)
0 TURN THE WATER ON AT THE
1
Tighten any connections that leak.
Compression
Nut
Ferrule (sleeve)
Check to see if leaks occur at the water line
connections.
1 PLUG IN THE REFRIGERATOR
1
1 2 START THE ICEMAKER
Never use old or used hoses. Always use
new ones to have a better use and
experience. Connect always to a potable
water source to avoid security and health
issues.
¼ in. Tubing
Refrigerator
Connection
SHUTOFF VALVE
CAUTION
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back
to the wall.
Set the icemaker power switch to the
position.
The icemaker will not begin to operate until
it reaches its operating temperature of 15°F
(–9°C) or below. It will then begin operation
automatically if the icemaker power switch
is in the ON (I) position.
WARNING
ON