Operating Instructions (24 – 45) Intended use Safety instructions Product features Included in the box Unpacking and setting up Overview and description of parts Control panel Fan speeds Timer function Quiet function Air quality indicator Filter replacement indicator Daylight sensor IR receiver Air quality sensor Remote control (when using for the first time)
Introduction Thank you for choosing a device from IDEAL. Intended use • The device is used exclusively for cleaning the ambient air indoors. • Please read these operating instructions before starting to use the device and please follow the safety instructions. The operating instructions must be kept available with the device at all times.
Page 6
Safety instructions • Do not block the air intake and outlet. • Keep the device away from sources of heat such as direct sunlight or radiators, etc. • Make sure that no water vapour comes into contact with the device. •...
Product features • Filter replacement indicator: An illuminated red replacement indicator on the air purifier indicates that the filter cartridge needs to be replaced. • Air purification in 5 speed settings • 3-stage air purification system: Pre-filter, HEPA filter coated with activated carbon •...
Unpacking and setting up Installation guidelines for optimum performance: • The air intake ducts on the top can be used as handles (see adjacent diagram). • Place the device at least 10 cm away from the wall. • Keep the device away from areas subjected to draft (wind). •...
Page 9
Unpacking and setting up Hold the filter cartridge with both hands using the recessed grips provided and turn it anti-clockwise (9.). Take out the filter cartridge (10.) and remove the protective film (11.). Insert the filter cartridge with the three tabs in the notches provided and lock in position by turning clockwise (12.).
Control panel On/off button Air quality indicator Quiet button Fan speed button Timer button Fan speed indicator Timer indicator Filter replacement Daylight sensor Air quality sensor Quiet indicator indicator IR receiver Note: The air quality sensor (L) is recalibrated the first time you switch it on (A) and after being disconnected from the mains power supply.
Control panel On/off button Air quality indicator Quiet button Fan speed button Timer button Fan speed indicator Timer indicator Filter replacement Daylight sensor Air quality sensor Quiet indicator indicator IR receiver Fan speeds • Press the on/off button (A) to switch the air purifier on or off. •...
Control panel On/off button Air quality indicator Quiet button Fan speed button Timer button Fan speed indicator Timer indicator Filter replacement Daylight sensor Air quality sensor Quiet indicator indicator IR receiver Quiet function The Quiet button (D) is provided for particularly low-noise, unobtrusive operation (e.g.
Remote control Battery usage • Always use 3V lithium batteries CR2025 for the remote control. • Incorrect battery usage may result in leakage of battery fluid and/or damage. • If the remote control is not going to be used for a long time, please remove the battery. Unsuitable location •...
Replacing the battery • Open the battery compartment by pressing (A) and pulling out (B) at the same time. Take out the flat battery. • Insert a new battery into the battery compart- ment, making sure the polarity is correct (+ / -). •...
Remote control On/off button Quiet button Automatic button Turbo Auto Timer buttons Fan speed buttons Locking button Function M: Select the required fan speed Switches the air purifier to automatic mode Switches the air purifier on/off Switches the air purifier to Quiet mode Select the required timer time Press the locking button to lock the buttons on the control panel (air purifier).
Page 17
Filter replacement (e.g. in accordance with the filter replacement indicator F, see page 33) Note: Only original IDEAL filter cartridges (order from www.ideal.de) may be used. No tools are required to replace the filter cartridge. CAUTION: Disconnect the mains plug! The front panel is hooked in at the bottom in two places, and kept shut with 4 magnets.
App Control Your purifier can additionally be controlled by the "IDEAL AIR PRO" App via your smartphone (iOS /Android). For information, please see www.ideal-air.de Cleaning and maintenance CAUTION: Disconnect the mains plug prior to any cleaning or maintenance work! • Replace the filter cartridge as soon as the filter replacement indicator (F, page 33) lights up. The average life expectancy of the filter is approx.
Troubleshooting The air purifier won't switch on. Is the power cable securely connected to the back of the device? Make sure that the power cable is not damaged in any way. Check both ends of the power cable. Make sure that these are plugged in and that the purifier is connected to the power supply (page 29).
Page 20
Troubleshooting The indicators on the control panel do not Is the air purifier switched on? light up at all. Switch the air purifier on by pressing the on/off button (A, page 31). Has the Quiet function been activated? Disable the Quiet function by pressing the Quiet button (D, page 33).
Page 21
Troubleshooting The air purifier is making loud noises. Is the filter cartridge really dirty? Clean the pre-filter with a vacuum cleaner. Is the air purifier located on an even surface? Place the device on an even surface. Is the air purifier running at a high fan speed? ...
Technical data IDEAL AP60 Pro: Power supply 200-240V 50/60Hz / 100-120V 50/60Hz Power consumption 90W (200-240V) / 75W (100-120V) Suitable for rooms 50 to 70 m² * Air flow rate (max.) 600 m³/h Dimensions (L × W × H) 468 ×...
Page 23
Terms of warranty IDEAL provides a warranty for this device from the date of purchase. The terms of warranty are defined by our local representative. • If a material or design defect occurs during the warranty period, IDEAL shall repair or replace the device, or repay the purchase price, at its discretion.
Page 24
The company Krug + Priester has the following certifications: • Quality management system according to DIN EN ISO 9001:2015 • Environmental management system according to DIN EN ISO 14001:2009 • Energy management system according to DIN EN ISO 50001:2011...
Page 25
This machine is GS-tested and conforms to the following EC guidelines: • 2014/35/EU for electrical safety • 2014/30/EU for electromagnetic compatibility. • 2011/65/EU RoHS. For specific technical data, please refer to the information on the identification plate of the machine. To file a warranty claim, the device must still bear its original identification plate.
Page 26
Krug & Priester GmbH & Co KG Simon-Schweitzer-Str. 34 D-72336 Balingen (Germany) Printed in Germany 06-2017 15.05.2017 zm...
Need help?
Do you have a question about the IDEAL LUFT AP60 Pro and is the answer not in the manual?
Questions and answers