Related Manuals for Milwaukee M12 FUEL CD
Summary of Contents for Milwaukee M12 FUEL CD
- Page 1 OPERATOR'S MANUAL Cat. No. M12 CD M12™ FUEL™ 1/4" HEX 2-SPEED SCREWDRIVER TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.
-
Page 2: Work Area Safety
general poWer Tool safeTy Warnings Warning read all safeTy Warnings and all insTrucTions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious save all warnings and instructions for future reference. injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. • R emove any adjusting key or wrench before Work area safeTy turning the power tool on. A wrench or a key left • K eep work area clean and well lit. -
Page 3: Specific Safety Rules
• M aintain labels and nameplates. These carry important information. If unreadable or missing, contact a service facility for a MILWAUKEE ® replacement. • W ARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. -
Page 4: Specifications
SPECIFICATIONS Capacities No Load Wood Cat. No. Volts DC Steel Screws (dia.) Flat Bit Auger Bit LO 0-450 M12 CD 10mm (3/8") 6.35 mm (1/4") 28.5mm (1-1/8”) 25.4mm (1") HI 0-1700 assembly funcTional descripTion Warning Recharge only with the charger specified for the battery. For spe- cific charging instructions, read the operator’s manual supplied with your charger and battery. -
Page 5: Operation
operaTion Warning Always remove battery pack before changing or removing acces- sories. Only use accessories specifically recommended for this tool. Others may be hazardous. Warning To reduce the risk of injury, wear safety goggles or glasses with side shields. Fuel Gauge To determine the amount of charge left in the bat- tery, pull the trigger. - Page 6 Starting, Stopping and Controlling Speed The torque specifications shown here are approximate 1. To start the tool, grasp the handle firmly and pull values obtained with a fully charged battery pack. the trigger. Torque NOTE: An LED is turned on when the trigger is Clutch pulled.
-
Page 7: Maintenance
When drilling in wood, composition materials and plastic, properly, return the tool, charger and battery pack, tart the drill slowly, gradually increasing speed as to a MILWAUKEE ® service facility for repairs. you drill. When drilling into wood, use wood augers or twist drill bits. -
Page 8: Warranty - Australia And New Zealand
® Duty . Your satisfaction with our products is very important to us! If you encounter any problems ® with the operation of this tool, please contact your authorised MILWAUKEE dealer or service centre. For a list of MILWAUKEE ®...