Osd Initial Language Settings - Optional; Initial Setting The Area Code - Optional; Adjust The Settings - LG HW554PH Manual

HW554PH-D0_BDEULL_ENG_0722 1/8/09

OSD Initial language settings - Optional

During the first use of this unit, the initial language setup menu
appears on your TV screen. You must complete initial language
selection before using the unit. English will be selected as the initial
language.
1 Turn the power on :
The language list appears
2 Select the language :
3 Press :
4 To confirm press :

Initial Setting the Area Code - Optional

When you use this unit for the first time, you have to set the Area
Code as shown below.
1 Display setup menu :
2 Select LOCK menu on the first level :
3 Move to second level :
The activated Area Code appears on the
second level.
4 Move to the third level :
5 Enter a new password :
6 Recheck the entered new password :
7 Select a code for a geographic area :
After select, Rating and Password will be
activated. (page 21)
8 To confirm what you press :
Make sure to finish setting the Area Code
before leaving the setup menu if you cannot
set the rating and Password
12
9:28 AM Page 12

Adjust the settings

1 Display setup menu :
2 Select a desired option on the first level:
ON REMOTE
3 Move to second level:
4 Select a desired option on the second level:
POWER
5 Move to third level:
U U u u I I i i
6 Change the setting:
ENTER
I I i i and ENTER
Adjust the settings - more you can do
Adjust the language settings
OSD – Select a language for the Setup menu and on-screen display.
ON REMOTE
SETUP
U U u u
Disc Menu/Audio/Subtitle – Select a language for the Menu/Audio/Subtitle.
[Original]: Refers to the original language in which the disc was recorded.
i i
[Others]: To select another language, press number buttons then ENTER to
enter the corresponding 4-digit number according to the language code list
i i
in the reference chapter (see page 21). If you make a mistake before
numerical buttons
pressing ENTER, press CLEAR.
(0-9) and ENTER
[OFF] (for Disc Subtitle): Turn off Subtitle.
numerical buttons
(0-9) and ENTER
U U u u I I i i and
ENTER
ENTER
There is displayed as "-" or other error mark on display when you
change OSD.
- Restart the unit
- Change function
- Disconnect and connect USB device.
ON REMOTE
SETUP
U U u u
i i
U U u u
i i
U U u u , ENTER