Table of Contents
Advertisement
HG3555A/42306 Portable Power Unit
Operation (cont'd)
Stopping the Power Unit (See Figure 4)
1. Move the two flow levers (1) to the NEUTRAL
position. Idle the power unit engine for a few
moments. Move the key switch (4) to the OFF
position.
2. Disconnect the tool hoses from the power unit.
See Hose Connections.
Retractable Handles
The handles on the power unit can be extended when
transporting the power unit or retracted for convenience
when connecting/disconnecting tool hoses, starting
power unit, etc. To use the handles in the extended
position for transport: Pull out the retaining pins (5), Pull
the handles fully out. Replace retaining pins (5) through
the handles into the holes in the cover of the power unit.
Lifting the Power Unit
Use the lifting eye and appropriate lifting equipment.
Make sure all components used to lift this power
unit are rated for 350 lbs (159 kg) and are securely
attached between the power unit and lifting
equipment. Inadequate components may fail
and cause the power unit to fall, resulting in injury
or property damage.
Stop the power unit engine before lifting. Take care
when attaching the lifting device (chain, strap, etc.) to
the lifting eye so as not to damage the power unit.
Greenlee Textron / Subsidiary of Textron Inc.
10
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Advertisement
Table of Contents
