PEUGEOT 807 Manual page 155

USING ROOF BARS
To use the transverse roof bars, release the four locking levers provided for this
purpose.
From the left-hand side, slide them in their rails to the required notch.
Lock the four locking levers located at the base of the feet of each bar.
Note: when the roof bars are not in use, position them at the rear stop to avoid
excess consumption.
Use accessories approved by Automobiles PEUGEOT and follow the manufac-
turer's fitting instructions.
Maximum authorised weight on the roof rack 220 lbs. (100 kg)
06-10-2003
PRACTICAL INFORMATION
Removal and refitting
of the roof bars
– Remove the bolt, the stop and the
two washers at each location A.
– Move the bars to the locations A.
– Lift the two bars to remove them.
– Imperative: refit the bolt, the stop
and the two washers at each loca-
tion A.
To refit, proceed in the reverse order.
Direction of use:
159