Operating Check - PEUGEOT 807 Manual

AUTOMATIC SWITCHING ON
OF LIGHTS
The side lights and dipped beam
headlamps switch on automatically if
the light is poor. They switch off
when the light becomes
enough.
Note: In foggy weather, the bright-
ness sensor can detect sufficient
light. As a consequence, the lights
will not come on automatically.
This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Start with the key in the acces-
sories position (1st notch),
Place the lights stalk in position 0,
Press the end of the stalk for more
than two seconds.
Note: after the ignition is switched off
and depending on the brightness, the
lights remain on for approximately
45 seconds or until the vehicle is
locked.
Do not cover the brightness sen-
sor located in the centre of the
fascia. It is used for automatic
switching on of the lights.
06-10-2003
YOUR 807 IN DETAIL

Operating check

Activation
Activation of this function is accom-
panied by an audible signal and the
bright
message "Automatic lighting active"
on the multi-function display.
Disarming
Disarming of the function is accom-
panied by an audible signal.
Note: the function is disarmed tem-
porarily when the driver uses the
manual lighting controls.
115