global_main.book.book Page 15 Wednesday, November 18, 2020 10:26 AM
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 50 kPa and
800 kPa (0.5‒8.0 kgf/cm²). If the water pressure
is more than 800 kPa, a decompression device
should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap with Thread
Screw the supply hose connector onto the water
supply tap.
Connecting Screw-Type Hose to Tap Without
Thread
1
Loosen the 4 fixing screws
2
3
4
.
a
INSTALLATION
Remove the guide plate
if the tap is too large
b
to fit the adapter.
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws.
Push the inlet hose
vertically upwards so
c
that the rubber seal within the hose can adhere
completely to the tap and then tighten the
hose by screwing it to the right.
15