Fresh Food Cold Wall (Rear Wall Of Refrigerator Compartment); Installation Requirements; Location Requirements; Electrical Requirements - Haier HRB10N2BGS Installation And User Manual

FRESH FOOD COLD WALL (REAR WALL OF REFRIGERATOR
COMPARTMENT)
Your new refrigerator features Cold Wall technology to better
store perishable food.
The rear wall of the refrigerator compartment promotes
moisture condensation, similar to what you see in the
produce aisles of a grocery.
The excess moisture will drip into the drain at the bottom of
the wall.

INSTALLATION REQUIREMENTS

LOCATION REQUIREMENTS

WARNING
Explosion Hazard
Keep ammable materials and vapors, such as gasoline,
away from appliance.
Failure to do so can result in death, explosion or re.
IMPORTANT: This refrigerator is designed for indoor,
household use only. This refrigerator should not be recessed
or built-in an enclosed cabinet. It is designed for freestanding
installation only.
To ensure proper ventilation for your refrigerator, allow at
least 1/4" (0.64 cm) of space on each side of the refrigerator
and 4" (10 cm) of space behind the refrigerator. The area
above the refrigerator should be open. When installing your
refrigerator next to a fixed wall, leave 4" (10 cm) minimum to
allow for the door to swing open.
¼" (0.64 cm)
4
a
NOTE: This refrigerator is intended for use in a location
where the temperature ranges from a minimum of 55°F
(13°C) to a maximum of 110°F (43°C). The preferred room
temperature range for optimum performance, which
reduces electricity usage and provides superior cooling, is
between 60°F (16°C) and 90°F (32°C). It is recommended that
you do not install the refrigerator near a heat source, such as
an oven or radiator, or in direct sunlight.

ELECTRICAL REQUIREMENTS

Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, re or
electrical shock.
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
4" (10.2 cm)
A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your refrigerator be provided.
Use an outlet that cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of installation or cleaning,
disconnect the refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to the electrical
source and reset the temperature controls to the desired
setting.
a
Moisture Condesation
WARNING
Electrical Shock Hazard