Operation - Greenlee 3561 Instruction Manual

Setup
1. Use the instructions provided with the Ultra Tugger
to set up the puller.
2. Plug the Speed Booster into a 120 volt, 20 amp
receptacle.
3. Plug the puller into the receptacle on the Speed
Booster.
Greenlee / A Textron Company
03561 Speed Booster

Operation

1. Turn on the Speed Booster using the circuit breaker/
power switch located in back of Speed Booster.
Note: The amber indicator will illuminate to indicate that
the power is ON.
2. Turn the puller on. Tail the rope as described in the
instruction manual supplied with the Ultra Tugger.
Note: Allow the puller to run at least 5 seconds before
engaging Speed Booster.
3. Press the toggle switch on the right to switch on
the high speed mode of the Speed Booster. The red
indicator will illuminate.
Note: It may be necessary to hold the switch momentarily.
4. Continue to tail the rope and monitor the force
gauge as usual.
Note: If the pulling force exceeds 2500 pounds, the
Speed Booster will switch off automatically. If the
pulling force drops to less than 2500 pounds, the Speed
Booster will not switch back on automatically; it must be
switched back on manually.
Note: If it becomes necessary to slow down the puller,
press the toggle switch on the left ("Low Speed") to shut
off the Speed Booster.
Note: If the Speed Booster is used for extended time
in the High Speed mode, the unit may heat up and
automatically activate the thermal shutdown. When this
happens, the Speed Booster will run the puller at normal
speed, but will not boost until it has had time to cool
down.
5. Finish the pull as described in the Ultra Tugger
instruction manual.
6. Turn off the Speed Booster using the power switch
located at the rear. Unplug the Ultra Tugger from the
Speed Booster, and unplug the Speed Booster.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070